Hologic ThinPrep 5000 - SECTION C: Internal Quality Control; SECTION D: Thinprep 5000 Hazards

ThinPrep™ 5000 Processor with AutoLoader Operator’s Manual 1.15
1
INTRODUCTION
INTERNAL QUALITY CONTROL
Power On Self-Test (POST)
When the ThinPrep
™
5000 processor with AutoLoader is powered on, the system goes through a self-
diagnostic test. The electrical, mechanical and software/communications subsystems are tested to
confirm that each performs properly. The operator is alerted to malfunctions by a message on the
touch screen interface and by audible sound (if enabled).
THINPREP 5000 HAZARDS
The ThinPrep 5000 processor with AutoLoader is intended to be operated in the manner
specified in this manual. Be sure to review and understand the information listed below in order
to avoid harm to operators and/or damage to the instrument.
If this equipment is used in a manner not specified by the manufacturer, then the protection
provided by the equipment may be impaired.
If any serious incident occurs related to this device or any components used with this device,
report it to Hologic Technical Support and the competent authority local to the patient and/or
user.
Warnings, Cautions and Notes
The terms WARNING , CAUTION and Note have specific meanings in this manual.
A
WARNING advises against certain actions or situations that could result in personal injury
or death.
A
CAUTION advises against actions or situations that could damage equipment, produce
inaccurate data or invalidate a procedure, although personal injury is unlikely.
A
Note provides useful information within the context of the instructions being provided.
SECTION
C
SECTION
D