Honeywell MPA2C3 - Configurations during Reversed Door Access Mode

MPA2C3 User Manual 119
Notifications in the Web User Interface
On every screen of the Web User Interface the following message will appear
%FACP Input% is the name of the input given in Panel Configuration/Advanced/
FACP Input/General.
In multi panel configurations the panel numbers are indicated where the Fire input
has been activated.
In Device Management you can see the below screen.
1. In Spaces& Doors, per Space a red indicator highlights the space where the
FACP has been triggered
2. In the highlighted Space another red indicator highlights the doors affected by
the FACP input alarm.
3. In Door Control a message in red wording appears:
4. CONTROLS HAVE NO EFFECT
Although you can change the status of the Door or Relay, these changes have no
effect and the door will remain in unlocked state.
%FACPinput%activated.
DooroutputsofPanel%1,%2…%32areinunlockedstate.
ControlshavenoeffectonDoor1,Door2,Door3(Aux1)andDoor4(Aux2)