36 MPA2C3 User Manual
• Holidays
• Access Group Name (access group details are panel-specific)
• Configuration (Site Codes)
Panel-specific data includes:
• Access Group Schedule Reader Assignments
• Space/Door/Reader Configuration
• Panel Configuration (General)
• Panel Configuration (Firmware Version)
• Panel Configuration (Network) (IP addresses apply only to primary panel)
• Panel Configuration (Host/Loop Communications) (applies only to primary
panel)
• Panel Configuration (FACP input)
• Web Users (applies only to primary panel)
Configuring Host/Loop Communications
To maintain your MPA2C3 system configuration or to monitor its status, you must
connect to the panel using one of three modes:
• Host mode (monitor only) – a host software system, such as WIN-PAK™ or
MAXPRO Cloud, connects to the panel (through the primary panel, which has an
on-board PCI communications adapter). It enables you to monitor the system
status.
• Web mode (configure and monitor) – the web server connects to the panel and
enables you to configure the panel and monitor system status.
Setting Communication Parameters for WIN-PAK
1. Navigate to Host/Loop Communications:
• Dashboard > Panels > Host/Loop Communications, or
• Menu > Panel Configuration > Host/Loop Communications.
2. Click to select WIN-PAK.
To Next Page
Loading...
Need help?
General
