14 MPA2C3 User Manual
For hardware and wiring installation instructions, please see the Installation Guide
supplied. The MPA2 is designed to work with most operating systems and brows-
ers, but Honeywell recommends Chrome™ for the best performance.
Note: All information in this document (descriptions, technical specifications, pictures,
illustrations etc) are indicative only, not binding and can be changed without notice.
Nevertheless, this document remains valid.
Licensing
To obtain 4 Door access control system, user need to buy the specific license. Once
the license file is applied on the panel then user can use the 4-Door controller.
Please contact Honeywell Customer Support team for 4-door license.
Connecting to the Web Server
The MPA2 embedded web server is intended for supplementary and programming
purposes only. It has not been evaluated by UL294 evaluation consist of the stand
alone mode of this device for use as a monitoring station.
The embedded web server can be accessed through the following three connection
types:
• USB (via USB2 WEB MODE)
• Ethernet (via Eth1/PoE+- HOST) through a direct connection
• Ethernet (via Eth1/PoE+- HOST) through a Switch/LAN connection
Note: 1) The panel that you are connecting to the computer is the Primary panel. DIP SW1
Bit 3 on a Primary panel must be set to ON for a successful connection.
2) When creating a user in MPA2 -> Web server, the administrator should obtain and
maintain the consent.
Setting Up the USB Connection
Warning: Do NOT connect the USB cable to the panel until AFTER the drivers are installed.
Note: Honeywell recommends Chrome™ for the best performance.
To Next Page
Loading...
Need help?
General
