MPA2C3 User Manual 83
4. Or click Add near the bottom of the window to assign a card from an available
set of cards.
5. Enter a PIN (numbers only).
6. Optional: Enter a note, such as Department number, phone extension, or a
birthday, for example. Notes can be up to 20 characters.
7. Turn Trace on or off.
8.
Trace provides a record of the card holder’s path through the facility by sending an alarm
message to the alarm monitor whenever a card with trace enabled is presented at a reader.
9. Select a type of Usage.
10. If you select Temporary, then you must select an end date on the calendar.
11. If you select Limited, then you must select the maximum number of times the
card can be presented.
12. Select an Access Type: Employee, Supervisor, or VIP. See
User Access Types and
Functionality
section on page 123 for more about Access Types.
13. Click Save.
Tip: You can assign attributes from an existing set of cards.
At the bottom of the People & Cards
window, click
Add to open a list of available cards, then select a card to assign to this person.
Modifying a Person
1. Click the box next to the person’s name.
Figure 2-41 Modifying a Person
2. Make changes to the person, then click Save.
To Next Page
Loading...
Need help?
General
