MPA2C3 User Manual
Monitoring/Managing Doors
The panel supports 2 and 4 doors. The door status screen provides status for each
door’s egress, status, and tamper and also status of the door lock relay.
The Door Status screen enables you to:
• View the current status of each input (Normal, Alarm, Cut, Short, Unshunt/
Shunt).
• Shunt or un-shunt any input.
Shunt means that the input’s change of state is ignored. This
way you can allow a door to be held open without signaling an alarm. The default
state of an input point is "unshunted."
• Restore the input to its schedule. A schedule is a specified time period during
which the input will be shunted and the alarm deactivated (for schedule
management, see
Configuring Time Management section on page 33).
• View the current status of each output (Engergized, De-energized).
• Pulse, energize, or de-energize the Door Lock relay.
• Restore the Door Lock to its schedule.
Monitoring Inputs
The panel supports door, panel, and auxiliary inputs. The door inputs provide
egress, status, and tamper monitoring. The auxiliary inputs support any monitor-
ing devices connected.
The Input Status screen enables you to:
• View the current status of each input (Normal, Alarm, Cut, Short, Shunt).
• Shunt or unshunt any input.
Shunt an input to ignore a change of state. This way you
can allow a door to be held open without falsely signaling an alarm. The default
state of an input point is “unshunted.”
• Restore the input to its schedule. A schedule is a specified time period during
which the input will be
shunted and the alarm deactivated.
Please Refer Chapter 4 for FACP Monitoring Inputs.
Navigating to the Spaces & Doors tab:
Click to open the menu, then click Device Management.
To Next Page
Loading...
