CHAPTER
2
MPA2C3 User Manual 27
BASIC SETTINGS
Basic Settings
Overview
This chapter explains the MPA2C3 configuration functions as accessed via the web
server. These functions should be performed only by the system administrator or
service personnel.
Caution:
The sequence of MPA2C3 configuration tasks is critical. If you do not follow the
sequence described in
Table 2-1, the system cannot be successfully configured.
Note: Screen captures taken on a Windows 7 platform. If you use another OS, then the GUI
might be different.
Table 2-1 Configuration Task Sequence
To... Go here...
Configure the System
via EVL (Ethernet Virtual
Loop)
Configuring the EVL (Ethernet Virtual Group) section on page
28
OR
Configure the system
via RS485
Configuring the System Via RS-485 Loop on page 22
Initial panel setup Initial Panel Setup section on page 41
Configuring schedules Configuring Schedules section on page 45
Configuring spaces 2-Door Inputs Configuration Interface section on page 61
Configuring people and
cards
Configuring People and Cards section on page 82
Configuring access
groups
Configuring Access Groups section on page 89
To Next Page
Loading...
