Honeywell MX8000 - Page 89

Section 5 – Programming
5–33
Table 5–11: Line Device Menu Options (cont’d)
Select
Device
Type
Line
Device
Menu
Choice Choice Choice Choice Default Comments
CID Monitor
Norm, Pream,
DTMF, or
Marks
Norm
CID Gain
–6, –2, 0, 2,
3.5, 4.8, 6, or
7dB
2dB
On Hook
Gain
2, 3.5B, 4.8,
6, or 7dB
7dB
Edit Line
(cont’d)
Line #
(cont’d)
Line Gain
Opt (cont’d)
Ringer
Impedance
Hi or Sy Hi
Used to set Caller ID
detection methods,
gain, and impedance.
See Section 5.5.2.7
for more information.
These options are
only used if Caller ID
is enabled as
described in Section
5.5.2.5.
Use Default Device #
Choose Device(s) #
that you wish to be
programmed to factory
defaults.
Copy
Device(s)
Copy
Existing
Device # of
Source &
Target
Device
Copy the program-
ming of one Device
(source) and paste it
into one or several
(target) Devices.
Clear
Device
Choose
Device #
Deletes a Device from
the receiver.
MX8000–
LC3
3 Line
(cont’d)
View
Device
Choose
Device #
Views what Devices
are installed.
Use
Defaults
Add
Device
Device #
Copy
Existing
Central
Station #
000-255
017
Odd/Even
Network
Odd/Even Even
VPN Yes/No No
A/B Network A/B A
Edit Line
Monitor
Station Flag
Yes/No No
Use Default Device #
Choose Device(s) #
that you wish to be
programmed to factory
defaults.
Copy
Device(s)
Copy
Existing
Device # of
Source &
Target
Device
Copy the
programming of one
Device (source) and
paste it into one or
several (target)
Devices.
Clear
Device(s)
Choose
Device #
Deletes a Device from
the receiver.
MX8000–
LRR
View
Device(s)
Choose
Device #
Views what Devices
are installed.