Honeywell XENON 1902 - Page 314

294 Xenon/Granit User Guide
GS1-128 Default All GS1-128 Settings GS1DFT 204
*On GS1ENA1 204
Off GS1ENA0 204
GS1-128 Message Length Minimum (1 - 80) *1 GS1MIN## 205
Maximum (0 - 80) *80 GS1MAX## 205
Telepen Default All Telepen
Settings
TELDFT 205
*Off TELENA0 205
On TELENA1 205
Telepen Output *AIM Telepen Output TELOLD0 205
Original Telepen Output TELOLD1 205
Telepen Message Length Minimum (1 - 60) *1 TELMIN## 206
Maximum (1 - 60) *60 TELMAX## 206
UPC-A Default All
UPC-A Settings
UPADFT 206
Off UPBENA0 206
*On UPBENA1 206
UPC-A Check Digit Off UPACKX0 207
*On UPACKX1 207
UPC-A Number System Off UPANSX0 207
*On UPANSX1 207
UPC-A 2 Digit Addenda *Off UPAAD20 207
On UPAAD21 207
UPC-A 5 Digit Addenda *Off UPAAD50 207
On UPAAD51 207
UPC-A Addenda Required *Not Required UPAARQ0 208
Required UPAARQ1 208
Addenda Timeout Range (0 - 120) *500 DLYADD##### 208
UPC-A Addenda
Separator
Off UPAADS0 208
*On UPAADS1 208
UPC-A/EAN-13 with Extended
Coupon Code
*Off CPNENA0 209
Allow Concatenation CPNENA1 209
Require Concatenation CPNENA2 209
Addenda Timeout Range (0 - 120) *500 DLYADD##### 209
Coupon GS1 DataBar Output GS1 Output Off CPNGS10 210
GS1 Output On CPNGS11 210
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page