HP 8114A - How to Remove PC Boards from Plastic Support Clips; Front Panel Subassemblies

HP 8114A Service Guide
Figure 4-17. Front Panel Subassemblies
How to Remove PC Boards from Plastic Support Clips
Some of the Front Panel subassemblies are held in position by plastic
support clips. Hemove them as follows:
1. Using a knife or other suitable tool, gently release the PC board
from its support clips, starting with the clips at one corner of the
board and working along the board, raising it slightly as each clip is
released. Move the clips just sufficiently to release the board.
2. When both ends of the board and one side have been released from
the clips the board can be slid out from the clips on the remaining
side.
Caution
0
Do not use excessive pressure on PC board support clips, as they may
be damaged.
4.22 Disassembly and Reassembly