HP 8114A - Removing the Variable Baseline (if Option 001 Is Installed); Refitting the Variable Baseline; Location of the Variable Baseline (Option 001)

EIP 8114A Service Guide
Removing the Variable Baseline (If Option 001 is installed)
The Variable Baseline is, if original, or retrofitted, also mounted on the
power supply slide. See Figure 4-6.
I I
V/IRIABLk
BASELINE
MODULE
(OPTION 001;
POWER
SUPPLY
, SLIDE
1'
Figure 4-6. Location of the Variable Baseline (Option 001)
1. Follow the instructions for Removing the Power Supply.
2. Remove the 4 screws at the bottom of the power supply slide,
securing the variable baseline module to the slide.
3. Remove the variable baseline module.
Refitting the Variable Baseline
1. Refitting the variable baseline is the reverse procedure of removal.
Note
3
The variable baseline module has two holes at the bottom - below the
connector - , These holes have to fit onto the two spacers which are
mounted on the power supply slide.
2. Secure the variable baseline module with the 4 screws.
84-8 Disassembly and Reassembly