BP
8114A
Service Guide
Warning
9
This instrument contains a lithium battery. The battery is not
user-replacable and replacement should only be carried out by
qualified service personnel.
There is a danger of explosion if the battery is incorrectly
replaced.
The battery must be replaced with the same or equivalent type
(HP Part No. 1420-0394). Discard used batteries according to local
regulations.
Operating Environment
A
4
Warning
a
The HP 8114A is not designed for outdoor use. Do not expose
the HP 8114A to rain or other excessive moisture. Protect the
FlP
8114A from humidity and temperature changes which could
cause condensation within the instrument.
n
’ Do not operate the HP 8114A in the presence of flammable
gases, fumes or powders. Operation of any electrical
instrument in such an environment constitutes a definite safety
hazard.
.
4
A
When working with output voltages of 30
-
1OOV
amplitude, the output voltage can be dangerous to life. Care
should therefore be taken when connecting the HP 8114A
to
external devices.
.
4
A
When working in
HIZ
(High-Z) mode, if you remove
the external load the output voltage can be higher than the
programmed voltage.
V,,
can be as much as 130
V,
even when
set as low as 2 V,,.
1-4 Installing the HP
g114A
To Next Page
Loading...
Need help?
General
