EIP
8114A Service Guide
How to Make a Firmware Update for HP 8114A
Supported Hardware
HP 8114A serial number 3330Gxxxxx and higher
Procedure
1.
Switch off the HP 8114A
2. Put the Memory Card in the slot at the right-hand side of the
front panel with the arrow on the card at the same side as the
arrow on the front panel (the card will not fit if inserted the
wrong way round)
3.
Simultaneously, press digit keys 1 and 3 with your right hand
4. While holding both keys down, switch HP 8114A ON
5. When
HP8114A
Selftest
appears on the display in very large letters, release the keys
6. After some seconds the message:
HP8114 Boot Program...
appears
7. If you get the message:
Firmware is not newer
then an update is unnecessary: Press the
MD
softkey
8. You may get a message like:
There is 1 board unknown. Load anyway.
Press the YES
softkey.
The EPROMs are now erased and re-loaded:
n
The first EPROMS will now be erased and this message is
displayed:
Erase U6 and
Ui’;
please wait.
n After one or two minutes you will hear a short beep and the
next EPROMs will be erased:
Erase U8 and
U9;
please wait.
n After another one or two minutes, you will hear a short beep
and the final EPROMs will be erased:
Erase U41 and U42; please wait.
I
After the next beep the following message is displayed:
Program all Flash Eproms; please wait.
n After the final beep you get the message:
Loading Finished
l-6
Installing the HP 6114A
To Next Page
Loading...
