HP 8114A - Removing the Power Supply; Rear Panel View Showing the Lever Point for the Screw; Power Supply and Primary Section Shielding Location

HP 8114A Service Guide
Removing the Power Supply
1. Remove the 8 screws securing the power supply slide at the rear
panel of the chassis. See Figure 4-4.
2. Disconnect the power supply from the motherboard by levering
the power supply slide with a flat screwdriver at the lower right.
hand side corner at the rear panel (close to the fuse), then pull the
power supply slide out of the chassis. Figure 4-4 shows the lever
point, at the rear panel.
b&yb&y
FIXING SCREWSFIXING SCREWS
Figure 4-4.Figure 4-4.
Rear Panel View Showing the Lever Point for the Screw DriverRear Panel View Showing the Lever Point for the Screw Driver
FANNO
--.._
-- ?owEa
SUP?LY
.” SECURING
,/” SCREWS
-~~
Figure 4-5.
Power Supply and Primary Section Shielding Location
4-6 Disassembly end Reassembly