Disassembly and Reassembly
This chapter enables you to disassemble the
HP 8114A
15MHz
lOOV/2A
Pulse Generator down to the
levels necessary for removal and replacement of faulty subassemblies.
Some of the subassemblies need to be removed in a specific order, and
the instructions have been written with this in mind.
Reassembly uses the removal steps in reverse, unless otherwise noted.
The instructions can also be used to provide the steps needed for
retrofitting subassemblies.
A flowchart shows the order of steps needed to get to a specific part
of the instrument.
Warning
Do not open the instrument before the AC line power cord is
disconnected. The output voltages, and the voltages in the
primary section of the power supply can be dangerous to life.
ESD Protection
A
ATTENTION! STATlC SENSITIVE DEVICES: You must
AhA
perform disassembly and reassembly
1:~
static save
ATTENTION
ststlc
smrltlvo
work areas only.
Disassembly and Reassembly
4-l
To Next Page
Loading...
Need help?
General
