HP 8114A - Test 5.2: Width Jitter; Test Specifications; Equipment Needed; Procedure

Test 5.2: Width Jitter
Test Specifications
RMS-<Jitter 0.03% + 25 ps (0.05% + 25 ps for 50 ns < width <
100 ns)
Equipment Needed
Digitizing Oscilloscope with Accessories
Delay Line (22 ns)
Power Splitter
All cables 50 0, coaxial, BNC, 122cm (4ft)
High Power Attenuator
Procedure
1. Connect HP 8114A to the Scope as shown:
tip RI 14A :IINDEII’ TEST II ”
1 BNC CABLE
Equipment Set-up for Jitter Test
3-20 Testing the HP g114A