HP 8163A - Page 19

19
Table of Contents
What is a Wavelength Sweep ? .......................................... 109
How to Set the Wavelength Sweep .................................... 110
The Sweep Parameters 110
How to Set the Repeat Mode 110
How to Set the Maximum Power for the Sweep
Range 111
How to Perform a Sweep .................................................... 111
How to Execute a Stepped Sweep 112
How to Execute a Continuous Sweep 114
How to Perform a Manual Sweep 115
5.5 How to Modulate a Signal ......................................116
How to Use the Internal Modulation .................................. 117
How to Set the Output Power of a Modulated Signal
117
How to Set the Frequency of a Modulated Signal 117
How to Set the Modulation Mode 117
How to Use External Modulation ....................................... 118
External Digital Modulation 118
External Analog Modulation 119
Wavelength Locking 120
External Digital Modulation using Input Trigger
Connector 121
How to Increase Linewidth 122
How to Set the Output Power of a Modulated Signal
123
How to Configure the Modulation Output ......................... 123
How to Set the BNC Output Line Mode as a Modu-
lation Output 123
How to Set the Modulation Output Mode 123
5.6 How to Use Triggers ...............................................124
How to Use Input Triggering .............................................. 124
How to Use Output Triggering ........................................... 125