HP 9000 Series Service Manual

Chapter 11 11-19
SCSI Peripherals and I/O Information
3B 01 Tape position error at Beginning Of Medium
3B 02 Tape Position Error at End of Medium
3B 08 Reposition Error
3B 0D Medium Destination Element Full
3B 0E Medium Source Element Empty
3D 00 Invalid bits in IDENTIFY message
3E 00 Invalid Microcode
3E 00 Logical Unit has not Self Configured Yet
3F 00 Target operating conditions have changed
3F 01 Microcode has changed
3F 02 Changed Operating Definition
3F 03 INQUIRY data has changed
40 00 Diagnostic or RAM failure
40 01 DRAM Parity Error
40 XX Diagnostic Failure (XX = FRU)
40 80 Power on Diagnostic failure
40 80 Diagnostic Failure (Vendor Specific)
40 81 Diagnostic Failure on Memories
40 82 Diagnostic Failure on CD-ROM ECC Circuit
40 83 Diagnostic Failure on Gate-Array
40 84 Diagnostic Failure on Internal SCSI Controller
41 00 Data path diagnostic failure
42 00 Power-On diagnostic failure
43 00 Message Error
44 00 Internal Controller/Target Error
44 00 Internal Software failure
45 00 Select/Reselect failed
46 00 Unsuccessful Soft Reset
47 00 SCSI Interface parity error
48 00 Initiator detected error
ASC ASCQ Description

HP 9000 Series Specifications

General

Operating System	HP-UX
Manufacturer	Hewlett-Packard (HP)
Series	9000
Type	Server
Processor	PA-RISC
Memory	Varies by model
CPU	PA-RISC processors
Expansion Slots	Varies by model
Networking	Ethernet
Form Factor	Rackmount
Models	A-Class, D-Class, E-Class, K-Class, N-Class, RP Series, Superdome