Password: ftp
230 Guest login ok, access restrictions apply.
ftp> bin
NOTE: Use of the CLI fru save does not capture all required P6000 information and a
fru restore is likely to result in HP Command View inconsistencies which prevent normal
operations. Please use HP P6000 Command View for all normal save and restore operations.
200 Type set to I.
ftp> put HP StorageWorks MEZ50_FRU.bin
200 PORT command successful.
150 Opening BINARY mode data connection for 'HP StorageWorks MEZ50_FRU.bin'.
226 Transfer complete.
ftp: 6168 bytes sent in 0.00Seconds 6168000.00Kbytes/sec.
ftp> quit
221 Goodbye.
2. Update an iSCSI or iSCSI/FCoE module with the saved configuration data (see page 2-12)
by executing the fru restore CLI command. The fru restore command has the following
two options:
• Full restore restores all module configuration parameters, including IP addresses, subnet
masks, gateways, virtual port group settings, LUN mappings, and all other persistent
data.
• Partial restore restores only the LUN mappings and persistent data, such as discovered
FC targets and iSCSI initiators.
250 Using the iSCSI CLI
To Next Page
Loading...
Need help?
General
