Table 31 iSCSI or iSCSI/FCoE module log messages (continued)
FC processor failed to re-initialize in response to
an IOCTL disable request.
ErrorFC#%d: QLIoctlDisable:
Re-initialize adapter failed
106593
FC processor reported a link down condition.ErrorFC#%d: QLIsrEventHandler: Link
down (%x)
106803
FC processor reported an unexpected asynchronous
event. The mailbox registers provide status, event
code, and data related to the event.
ErrorFC#%d: QLIsrEventHandler:
Unexpected async event (%x),
MB1=%x, MB2=%x, MB3=%x,
106813
MB4=%x, MB5=%x, MB6=%x,
MB7=%x
FC controller reported an invalid Entry Status %x,
type %x.
ErrorFC#%d: QLProcessResponseQueue:
Invalid EntryStatus %x, type
%x
106847
FC controller failed to provide a heartbeat.ErrorFC#%d: QLTimer: Heartbeat
failed
106851
Driver has determined that the FC link is unreliable
and unusable due to the number of errors
encountered. The link has been taken down.
ErrorFC#%d: QLTimer: Link error
count (0x%x) exceeded, link
down
106853
FC processor was unable to obtain the number of
loop IDs required. This failure occurs only when the
FC processor is running multi-ID firmware.
ErrorFC#%d: QLReserveLoopId: out
of loop Ids
106912
Driver was unable to re-establish connection to the
target within the timeout and retry counts, and is
therefore marking it offline.
ErrorFC#%d: QLMarkDeviceOffline:
Device Id: %x marked
offline, cLinkDownTimeout =
%x, cPortDownRetryCount=%x
106928
FC processor is unable to log into the FC fabric
name server.
ErrorFC#%d: QLSnsGetAllNext: Name
server login FAILED %x
106948
Driver’s host (initiator) database is full.ErrorFC#%d: QLUpdateDeviceData: out
of slots in host database
107029
Driver’s target database is full.ErrorFC#%d: QLUpdateDeviceData: out
of slots in target database
107030
Driver’s host (initiator) database is full. Maximum
host database is 64.
ErrorFC#%d: QLUpdateDeviceDatabase
0x%x: GET_ID failed %x
107041
Drivers host (initiator) database is full.ErrorFC#%d: QLUpdateDeviceDatabase
0x%x: out of slots in host
database
107056
Driver was unable to re-establish connection to the
target within the timeout and retry counts, and is
therefore marking it offline.
ErrorFC#%d: QLUpdatePort 0x%x: out
of slots in host database
107078
FC controller failed a Flash write (address x data
x).
ErrorFC#%d: QLWriteFlashDword:
Write fails at addr 0x%x
data 0x%x
107984
FC controller failed the Get VP Database command
(for virtual port %d).
ErrorFC#%d: QLGetVpDatabase:
MBOX_CMD_GET_VP_DATABASE for
VP %d fatal error
108032
FC controller failed the Get VP Database command
(for virtual port %d) with status x.
ErrorFC#%d: QLGetVpDatabase:
MBOX_CMD_GET_VP_DATABASE for
VP %d failed %x
108033
FC controller reported failure status for an Execute
IOCB (input/output control block) command.
ErrorFC#%d: QLVerifyMenloFw:
EXECUTE_COMMAND_IOCB failed
MB0 %x MB1 %x
108049
275
To Next Page
Loading...
Need help?
General
