HP EVA P6000 - Page 274

Table 31 iSCSI or iSCSI/FCoE module log messages (continued)
FC processor failed to return diagnostic results.FatalFC#%d: qlutm_init: Failed to
return diagnostic result to
Bridge
102423
FC processor failed reset.FatalFC#%d: QLInitializeAdapter:
Reset ISP failed
102656
FC processor firmware load failed.FatalFC#%d: QLInitializeAdapter:
Load RISC code failed
102657
FC processor receive sequencer code load failed.FatalFC#%d: QLInitializeAdapter:
Load ISP2322 receive
sequencer code failed
102658
FC processor transmit sequencer code load failed.FatalFC#%d: QLInitializeAdapter:
Load ISP2322 transmit
sequencer code failed
102659
FC processor firmware checksum failed.FatalFC#%d: QLInitializeAdapter:
Verify Checksum command
failed (%x)
102662
FC processor firmware initialization failed.FatalFC#%d: QLInitializeFW: FAILED102680
FC processor paused due to internal parity error.FatalFC#%d:
QLInterruptServiceRoutine:
102688
Risc pause %x with parity
error hccr %x, Disable
adapter
FC processor returned an invalid interrupt status.FatalFC#%d:
QLInterruptServiceRoutine:
102689
Invalid interrupt status:
%x
FC processor system error.FatalFC#%d: QLIsrEventHandler:
System error event (%x),
102716
MB1=%x, MB2=%x, MB3=%x,
MB4=%x, MB5=%x, MB6=%x,
MB7=%x
Response queue entry contains an invalid handle.FatalFC#%d: QLProcessResponseQueue:
Invalid handle %x, type %x
102746
FC processor external SRAM parity error count
exceeded limit; FC port disabled.
FatalFC#%d: QLTimer: Ext Ram parity
error exceed limit cnt 0x%x,
limit 0x%x, Disabled adapter
102752
FC processor heartbeat failed.FatalFC#%d: QLTimer: Heartbeat
failed
102755
FC processor being restarted.`FatalFC#%d: QLRestartRisc: restart
RISC
102800
FC processor received a SCSI command for an
unknown target path or has run out of resources to
execute additional commands.
ErrorFC#%d: QLUtmReceiveIo: Path
invalid/FW No resource count
%x
106583
FC processor was disabled by an IOCTL request to
the driver.
ErrorFC#%d: QLIoctlEnable: Adapter
disabled
106589
FC processor firmware failed initialization. The
request to initialize was received by the driver in
an IOCTL request.
ErrorFC#%d: QLIoctlEnable:
Initialize FW error
106590
FC processor failed the external loopback test.ErrorFC#%d: QLIoctlRunDiag:
Diagnostic loopback command
failed %x % %x %x
106592
274 iSCSI and iSCSI/FCoE module log messages