HPE 3PAR Service Processor Setup Wizard
The 3PAR Service Processor Setup Wizard proceeds through the following wizard steps:
• Welcome
• Generate SP ID
• Networking
• Remote Support
• System Support Information
• Time and Region
• Change Passwords
• Summary
• Applying Settings
• Finish
Follow the instructions on each screen, and then click Next to proceed to the next wizard step.
To launch the wizards in 3PAR SmartStart:
1. Verify that the SP is powered on.
2. Click the Initialize Service Processor link in 2 Initialize Service Processor.
3. Enter the SP IP address and click OK.
NOTE: When configuring in a DHCP network environment, enter the VSP temporary IP
address.
NOTE: A security certificate error might occur when there is a problem with a web server's
use of the certificate and a blocking page will appear. You can ignore the warning and
continue to go to the website.
4. On the browser window, enter setupusr in the User Name box, and leave the password
box blank.
5. Click OK.
NOTE: The 3PAR Service Processor Setup Wizard might not display correctly when using
Microsoft Internet Explorer 10 with default security settings. If the wizard continues to display
incorrectly, try refreshing the browser page.
100 Service Processor and System Setup
To Next Page
Loading...
Need help?
General