HPE 3PAR Storage System Setup Wizard
The 3PAR Storage System Setup Wizard proceeds through the following pages:
• Welcome
• Enter Serial Number
• Verify Storage System
• Configure Networking
• Configure Time
• Change Password
• Verify Configuration
• Progress
• Results
To launch the 3PAR Storage System Setup Wizard in 3PAR SmartStart:
NOTE: The 3PAR Storage System Setup Wizard might not display correctly when using
Microsoft Internet Explorer 10 with default security settings. If the wizard continues to display
incorrectly, try refreshing the browser page.
1. On the 3 Setup storage system page, click the Setup storage system link.
2. Enter the SP IP address. Click OK.
NOTE: When configuring in a DHCP network environment, enter the VSP temporary IP
address.
NOTE: The 3PAR Storage System Setup Wizard might not display correctly when using
Microsoft Internet Explorer 10 with default security settings. If the wizard continues to display
incorrectly, try refreshing the browser page.
3. On the Windows Security dialog box, enter setupusr in the User Name box and the
password previously set during the SP setup.
4. Click OK.
108 Service Processor and System Setup
To Next Page
Loading...
