To Next Page

To Previous Page

For assistance with registering the Hewlett Packard Enterprise software licenses, see the Hewlett

Packard Enterprise Support website:

Hewlett Packard Enterprise Support Center (http://www.hpe.com/support/hpesc)

System Installation Options

The following installation options are available and these options connect to the network in the

same way:

• Installation of a Hewlett Packard Enterprise integrated rack—Components are installed

in a Hewlett Packard Enterprise rack and shipped. See “Hewlett Packard

Enterprise Factory-Integrated System Setup” (page 55).

• Installation of system components in an existing rack—System components are shipped

in separate packaging and are installed by a customer and/or authorized service personal

in existing third-party racks or Hewlett Packard Enterprise racks. See “System Component

Installation in Existing Rack” (page 59).

For configuration specifications and installation requirements, see the HPE 3PAR StoreServ

8000 Storage Site Planning Manual at

http://www.hpe.com/info/storage/docs

For information about supported hardware and software platforms, see the HPE Single Point of

Connectivity Knowledge (HPE SPOCK) website:

HPE SPOCK (http://www.hpe.com/storage/spock)

For supported versions of management, configuration, and host-based software, in the menu on

the left, under Software, click Array SW: 3PAR.

System Hardware Installation Checklist

Before installing the system hardware components, verify that the environmental requirements,

electrical requirements, and rack access in the HPE 3PAR StoreServ 8000 Storage Site Planning

Manual have been met and that you have the following:

• Standard AC power

• Host computer with access to software, BIOS, drives, and HPE 3PAR OS

• FC HBA, FC host cable, and power cord

• Network access

• SP connectivity

• Tools

• Rail kits

• System and its components

System Installation Options 13

HP HPE 3PAR StoreServ 8000 User Manual

Questions and Answers: