System Wizard Step 7—Verify Configuration
The Verify Configuration page shows all the selected options and this page cannot be modified.
• To modify the selected options, click Prev.
• To proceed to the next wizard step, click Next.
System Wizard Step 8—Progress
The Progress page shows the setup process and operation status. The Status column indicates
an operation is in progress with an arrow icon and indicates an operation is complete with a
check mark icon.
NOTE: Depending on the type of system configuration, the operation might take up to 30
minutes or longer to complete.
1. Verify that the Setup Progress operations have all completed.
2. Click Next to proceed to the next wizard step.
System Wizard Step 9—Results
The Setup Progress and Results page confirms the system is ready to use. Click Finish.
The system setup wizard has been completed.
NOTE: As of HPE 3PAR OS 3.2.2, additional security has been implemented by using strong
passwords for access by HPE 3PAR service user accounts. By default, time-based strong
passwords are enabled for HPE 3PAR service user accounts. For additional information about
strong passwords, see the Using Strong Passwords section in the HPE 3PAR StoreServ
Storage Concepts Guide.
Post-Installation System Tasks
The system setup is now complete. Perform the recommended tasks before using the system:
• Validating Remote Support
For more information, see “Validating Remote Support” (page 129).
• Identifying Physical Locations of the Logical Cage Numbers
For more information, see “Identifying Physical Locations of Logical Cage Numbers” (page
113)
• Setting up notifications, performing system Health Check and InSplore with SPOCC
For more information, see HPE 3PAR Service Processor Onsite Customer Care User's
Guide.
• Configuring Hosts and creating Virtual Volumes with 3PAR SmartStart
For more information, see HPE 3PAR StoreServ 8000 Storage SmartStart Software User's
Guide.
• Creating LUNs and using the 3PAR StoreServ Storage
For more information, see HPE 3PAR StoreServ Management Console User Guide at: http://
www.hpe.com/info/storage/docs
• Use the checkhealth -detail command, and if there are errors in the report, fix them
as needed.
For additional support and other resources, see “Support and other resources” (page 114).
112 Service Processor and System Setup
To Next Page
Loading...
