System Wizard Step 1—Welcome
The Welcome page shows the information that is required to complete the wizard and set up
the SP.
1. Obtain the following information:
• The 10-digit system serial number
NOTE: Legacy 3PAR StoreServ Storage systems had 7-digit serial numbers. To
install and configure your 3PAR StoreServ 8000 Storage, use the new 10-digit serial
number.
This requires up-to-date versions of 3PAR SP and VSP software and of 3PAR SmartStart.
• System name
• System networking information:
◦ IP address (IPv4 only)
◦ Subnet mask and gateway
• Time zone information:
◦ Date and time or Network Time Protocol (NTP) server address if using automatic
date/time configuration
◦ Time zone region
2. Click Next to proceed to the next wizard step.
HPE 3PAR Storage System Setup Wizard 109
To Next Page
Loading...
