8. (Optional) Install the cable management arm. See the instructions provided in the kit.
9. Use the straps provided in the kit to secure all fiber and Ethernet cables. Securing the cables
prevents any improper disconnection or damages during operation.
10. Connect the power cord to the facility power source. Do not power on the SP at this time.
WARNING!
To reduce the risk of electric shock or damage to the equipment:
• Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
• Plug the power cord into a grounded (earthed) electrical outlet where it is accessible at
all times.
• Unplug the power cord from the power supply to disconnect power to the equipment.
• Do not route the power cord through a walkway area or adjacent to other hardware
components that might pinch or damage the cord. Pay close attention to the plug,
electrical outlet, and the point where the cord extends from the component.
Continue on to “System Cabling” (page 79).
78 System Component Installation in Existing Rack
To Next Page
Loading...
Need help?
General