Table 29 System software installation checklist
3PAR StoreServ Storage system
3PAR StoreServ Storage serial number
The 3PAR StoreServ Storage system serial number can be obtained from the
following:
• Located at the rear of the system next to the power switch for the controller
node enclosure PCM
• Located in the product documentation provided with your system
3PAR StoreServ Storage system name
IP address (IPv4 only)
Subnet mask
Gateway IP address
Date and time:
• Copy from the SP
• Enter manually
• Use Network Time Protocol (NTP) server information
• Time Zone
New password to assign 3paradm (to access the system)
NOTE: Passwords for the 3paradm username can include all printable characters
and be between 6-8 characters in length.
HPE 3PAR SmartStart
Performing host configurations after using 3PAR SmartStart for installation setup
requires an available server to run Microsoft Windows Server 2008 R2, x64 Edition;
Windows Server 2012; or Windows 7.
System Software Installation Checklist 89
To Next Page
Loading...
Need help?
General