• IPv6 Static Address Assignment
• IPv6 SLAAC Address Assignment
• IPv6 Static Route Assignment
• IPv6 Static Default Gateway Entry
• DHCPv6 Stateful Address Assignment
• DHCPv6 Stateless DNS, Domain Name, and NTP Configuration
• Integrated Remote Console
• Onboard Administrator Single Sign-On
• HPE Single Sign-On
• Web Server
• SSH Server
• SNTP Client
• DDNS Client
• RIBCL over IPv6
• SNMP
• AlertMail
• Remote Syslog
• WinDBG Support
• HPQLOCFG/HPLOMIG over an IPv6 connection
• Scriptable Virtual Media
• CLI/RIBCL key import over an IPv6 connection
• Authentication using LDAP and Kerberos over IPv6
• iLO Federation
• IPMI
Configuring iLO SNTP settings
Prerequisites
• Configure iLO Settings privilege
• At least one NTP server is available on your management network.
• If you will use a DHCPv4-provided NTP service configuration, DHCPv4 is enabled on the IPv4 tab.
• If you will use a DHCPv6-provided NTP service configuration, DHCPv6 Stateless Mode is enabled on
the IPv6 tab.
• For DHCPv6 time settings configurations only: The server is configured to use the iLO Dedicated
Network Port. IPv6 is not supported in the Shared Network Port configuration.
176 Configuring iLO SNTP settings
To Next Page
Loading...
Need help?
General