Configuring iLO management settings
Agentless Management and AMS
Agentless Management uses out-of-band communication for increased security and stability. With
Agentless Management, health monitoring and alerting is built into the system and begins working the
moment a power cord is connected to the server. This feature runs on the iLO hardware, independent of
the operating system and processor.
To collect information from devices and components that cannot communicate directly with iLO, install the
Agentless Management Service (AMS).
Table 2: Information provided by Agentless Management with and without AMS
Component Agentless Management without AMS Additional information provided when
AMS is installed
Server health
• Fans
• Temperatures
• Power supplies
• Memory
• CPU
• NVDIMM
N/A
Storage
• Smart Array
• SMART Drive Monitoring (connected
to Smart Array)
• Internal and external drives connected
to Smart Array
• Smart Storage battery monitoring
(supported servers only)
• SMART Drive Monitoring (connected
to Smart Array, Smart HBA, and AHCI)
• iSCSI (Windows)
• NVMe drives
Network
• MAC addresses for embedded NICs
that support NC-SI over MCTP
• Physical link connectivity and link up/
link down traps for NICs that support
NC-SI over MCTP
• Fibre Channel adapters that support
Hewlett Packard Enterprise vendor-
defined MCTP commands
• MAC and IP address for standup and
embedded NICs
• Link up/link down traps
• NIC teaming and bridging information
(Windows and Linux)
• Supported Fibre Channel adapters
• VLAN information (Windows and
Linux)
Table Continued
Configuring iLO management settings 271
To Next Page
Loading...
