Action
Ensure that the group key matches for all iLO systems that are members of the selected group.
iLO peers are not displayed on iLO Federation pages
Symptom
iLO peers (systems in the same group as the local iLO system) are not displayed on iLO Federation
pages.
Action
• Ensure that the group key matches for all iLO systems that are members of the selected group.
• Wait for twice the configured multicast interval, and then refresh the iLO Federation page.
If an iLO system was reconfigured and can no longer communicate with the local iLO system, it will be
dropped from its peer relationships after they expire.
• If you are using server blades in an enclosure, verify that Enclosure iLOFederation Support is
configured on the Enclosure Settings > Network Access > Protocols page in the Onboard
Administrator web interface.
You must have Onboard Administrator 4.11 or later to configure this setting. This configuration is
required to allow peer-to-peer communication between the server blades in an enclosure.
• Verify that the switches in the network are configured to allow communication between iLO peers.
• Ensure that a communication path exists between the local iLO system and the peer with the error.
An intermediate firewall or a change to the iLO network configuration and HTTP port setting might
block communication between the local iLO system and the peer.
iLO peers are displayed with IPv6 addresses on IPv4 networks
Symptom
iLO peers on an IPv4 network are displayed with IPv6 addresses on iLO Federation pages.
Action
Verify that the iLO Client Applications use IPv6 first check box is not selected on the iLO Dedicated
Network Port - IPv6 page.
Firmware update issues
Unsuccessful iLO firmware update
Symptom
The following issues occur when you try to update the iLO firmware:
iLO peers are not displayed on iLO Federation pages 401
To Next Page
Loading...
Need help?
General