Logical drives
When the Logical View option is selected, the following information is listed for the logical drives
attached to a Smart Array controller.
• Logical drive number
• Status
• Capacity
• Fault Tolerance
• Logical Drive Type
• Encryption Status
Logical drives must be configured through the Smart Storage Administrator software before they can be
displayed on this page.
Physical drives
The information listed in this section depends on whether the Logical View or Physical View option is
selected. In the Logical View, physical drives that are configured as part of an array are listed. In the
Physical View, all physical drives are listed.
When a physical drive has a Failed status, this status does not affect the overall storage health status.
Only logical drives affect the storage health status.
The following information is listed for the physical drives attached to a Smart Array controller:
• Physical drive port, box, and bay numbers
• Status
• Serial Number
• Model
• Media Type
• Capacity
• Location
• Firmware Version
• Drive Configuration
• Encryption Status
Direct-attached storage details
Controllers
This section provides the following information about the Hewlett Packard Enterprise and third-party
storage controllers that manage direct-attached storage.
• Controller location
• Top-level controller status—The top-level controller status (displayed on the left of the controller
location) is a combination of the controller hardware status and the status of the enclosures, physical
drives, and spare drives associated with the controller. If the controller hardware status is OK, and any
66 Direct-attached storage details
To Next Page
Loading...
