depending on the failure type. If the controller hardware has a Failed status, the top-level controller
status is Failed.
• Controller Status—Controller hardware status (OK or Failed)
• Serial Number
• Model
• Firmware Version
• Controller Type
• Cache Module Status
• Cache Module Serial Number
• Cache Module Memory
• Encryption Status—Indicates whether encryption is enabled in the controller.
The following values are possible:
◦ Enabled
◦ Not Enabled
◦ Enabled-Local Mode—This value is displayed when you do not use a remote key management
server.
• Encryption ASIC Status—Indicates whether the ASIC encryption self tests for the controller passed
or failed. A failed status indicates that the controller is not encrypted.
• Encryption Critical Security Parameter NVRAM Status—Indicates whether the controller
successfully detected the critical security parameter NVRAM. A failed status means that the controller
is not encrypted.
The encryption settings for a Smart Array controller can be configured by using the Smart Storage
Administrator software.
Drive enclosures
This section provides the following information about the drive enclosures attached to a Smart Array
controller.
• Enclosure port and box numbers
• Status
• Drive Bays—The number of drive bays
• Serial Number
• Model
• Firmware Version
Some enclosures do not have all the listed properties, and some storage configurations do not have drive
enclosures.
Viewing general system information 65
To Next Page
Loading...
