Configuring Enclosure iLO Federation Support
If you want to use iLO Federation with server blades in a BladeSystem c-Class enclosure, the Enable
Enclosure iLO Federation Support option must be enabled in the Onboard Administrator software. This
setting is required to allow peer-to-peer communication between the server blades in an enclosure. The
Enable Enclosure iLO Federation Support option is enabled by default.
Procedure
1. Log in to the Onboard Administrator web interface (https://<OA hostname or IP address>).
2. Select Enclosure Information > Enclosure Settings > Network Access in the navigation tree.
The Protocols tab is displayed.
3. Select the Enable Enclosure iLO Federation Support check box, and then click Apply.
You can also use the CLI to enable or disable the Enable Enclosure iLO Federation Support option.
To enable the option, enter ENABLE ENCLOSURE_ILO_FEDERATION_SUPPORT. To disable the
option, enter DISABLE ENCLOSURE_ILO_FEDERATION_SUPPORT. For more information, see the
Onboard Administrator CLI user guide.
Verifying server blade support for iLO Federation
Procedure
1. Log in to the Onboard Administrator web interface (https://<OA hostname or IP address>).
2. Select Device Bays > <Device Name> > iLO in the navigation tree.
3. Verify that iLO Federation Capable is set to Yes.
Using the iLO Federation features
Selected Group list
All of the iLO Federation pages except for Setup have a Selected Group list.
92 Configuring Enclosure iLO Federation Support
To Next Page
Loading...
Need help?
General