Managing iLO reboots, factory reset, and NMI
Rebooting (resetting) iLO
In some cases, it might be necessary to reset iLO; for example, if iLO is not responding to the browser.
Using the Reset option does not make any configuration changes, but ends all active connections to the
iLO firmware. If a firmware file upload is in progress, it is terminated. If a firmware flash is in progress, you
cannot reset iLO until the process is finished.
iLO reset methods
• Click Reset on the Diagnostics page in the iLO web interface.
• Use the CLI or HPONCFG. For instructions, see the iLO scripting and CLI guide.
• Use the iLO 5 Configuration Utility.
• Use the server UID button on supported servers.
• Use the iLO RESTful API. For more information, see http://www.hpe.com/info/restfulapi.
• Use IPMI. For more information, see the iLO IPMI user guide.
If none of these methods are available or working as expected, you must power down the server and
disconnect the power supplies.
Rebooting (resetting) the iLO processor with the web interface
Prerequisites
Configure iLO Settings privilege
Procedure
1. Click Information in the navigation tree, and then click the Diagnostics tab.
2. Click Reset.
3. When prompted to confirm the request, click OK.
iLO resets and closes your browser connection.
Rebooting (resetting) iLO with the iLO 5 Configuration Utility
Prerequisites
Configure iLO Settings privilege
Procedure
1. Optional: If you access the server remotely, start an iLO remote console session.
2. Restart or power on the server.
3. Press F9 in the server POST screen.
The UEFI System Utilities start.
Managing iLO reboots, factory reset, and NMI 357
To Next Page
Loading...
Need help?
General