Trap
number
Trap name Description
9013 cpqSm2SecurityOverrideDisengaged iLO 5 detected that the security
override jumper has been toggled to
the disengaged position.
9017 cpqSm2ServerPowerOn The server has been powered on.
9018 cpqSm2ServerPowerOff The server has been powered off.
9019 cpqSm2ServerPowerOnFailure A request was made to power on the
server, but the server could not be
powered on because of a failure
condition.
9020 cpqSm2IrsCommFailure Communication with Insight Remote
Support or Insight Online has failed.
9021 cpqSm2FirmwareValidationScanFailed Firmware validation failure (iLO/ IE/
SPS firmware).
9022 cpqSm2FirmwareValidationScanErrorRepaired A reported firmware integrity scan
issue was repaired.
9023 cpqSm2FirmwareValidationAutoRepairFailed Firmware recovery failed.
11003 cpqHo2GenericTrap Generic trap. Verifies that the SNMP
configuration, client SNMP console,
and network are operating correctly.
You can use the iLO web interface to
generate this alert to verify receipt of
the alert on the SNMP console.
11018 cpqHo2PowerThresholdTrap A power threshold has been exceeded.
11020 cpqHoMibHealthStatusArrayChangeTrap A change in the health status of the
server has occurred.
5022 cpqSasPhyDrvStatusChange AMS detected a change in the status of
an SAS or SATA physical drive.
14004 cpqIdeAtaDiskStatusChange AMS detected a change in the status of
an ATA disk drive.
16028 cpqFca3HostCntlrStatusChange AMS detected a change in the status of
a Fibre Channel host controller.
18011 cpqNic3ConnectivityRestored Connectivity was restored to a logical
network adapter.
18012 cpqNic3ConnectivityLost The status of a logical network adapter
changed to Failed.
Table Continued
288 Configuring iLO management settings
To Next Page
Loading...
Need help?
General