HPE FlexNetwork 5510 HI Series Fundamentals Configuration Guide

94
starts overwriting the target next-startup configuration file after the save operation is complete.
If a reboot or power failure occurs during the save operation, the next-startup configuration file
is still retained.
Use the safe mode if the power source is not reliable or you are remotely configuring the device.
To save the running configuration, use either of the following command in any view:
Task
Command
Remarks
Save the running configuration
to a configuration file without
specifying the file as a
next-startup configuration file.
save
file-url [
all
|
slot
slot-number ]
N/A
Save the running configuration
to a configuration file and specify
the file as a next-startup
configuration file.
save
[
safely
] [
backup
|
main
] [
force
]
This command saves the configuration
to a file in the root directory of the flash
memory.
F
or reliable configuration saving,
specify the
safely
keyword.
If you specify only the
safely
keyword,
the command saves the configuration to
the main startup configuration file.
If the
force
keyword is specified, the
command saves the configuration to the
existing next-startup configuration file.
If the
force
keyword is not specified, the
command allows you to specify a new
next-startup configuration file.
Configuring configuration rollback
To replace the running configuration with the configuration in a configuration file without rebooting
the device, use the configuration rollback function. This function helps you revert to a previous
configuration state or adapt the running configuration to different network environments.
The configuration rollback function compares the running configuration against the specified
replacement configuration file and handles configuration differences as follows:
•
If a command in the running configuration is not in the replacement file, the rollback function
executes the undo form of the command.
•
If a command in the replacement file is not in the running configuration, the rollback function
adds the command to the running configuration.
•
If a command has different settings in the running configuration and the configuration file, the
rollback function replaces the running command setting with the setting in the configuration file.
To facilitate configuration rollback, the configuration archive function was developed. This function
enables the system to save the running configuration automatically at regular intervals.
Configuration task list
Tasks at a glance
(Required.) Configuring configuration archive parameters
(Required.) Perform either task:
• Enabling automatic configuration archiving
• Manually archiving the running configuration

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English