HPE FlexNetwork 5510 HI Series

80
Configuring the device as an IPv6 TFTP client
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. (Optional.) Use an ACL to
control the client'
s access
to TFTP servers.
tftp-server ipv6 acl
acl-number
By default, no ACL is used for access
control.
3. S
pecify the source IPv6
address for TFTP packets
sent by the TFTP client.
tftp client ipv6 source
{
interface
interface-type
interface-number |
ipv6
source-ip-address }
By default, no source IPv6 address is
specified. T
he source address is
automatically selected as defined in
RFC 3484.
4. Return to user view.
quit
N/A
5. Download or upload a file in
an IPv6 network.
tftp ipv6
tftp-server [
-i
interface-type
interface-number ] {
get
|
put
|
sget
} source-filename
[ destination-filename ]
[
vpn-instance
vpn-instance-name ] [
dscp
dscp-value |
source
{
interface
interface-type interface-number
|
ipv6
source-ipv6-address } ] *
The source IP address specified in
this command takes precedence
over the one set by the
tftp client
ipv6 source
command.
Use this command in user view.