HPE FlexNetwork 5510 HI Series Fundamentals Configuration Guide

136
Setting the table capacity mode
The switch supports multiple table capacity modes, as shown in Table 13. The table capacity mode
determines the capacities of the MAC address table, ARP or ND table, MPLS incoming label
mapping table, and VLAN mapping table.
Table 13 Table capacities in different table capacity modes
Table capacity mode
0
1
2
MAC address table capacity 32K 64K 32K
ARP/ND table capacity
16K ARP table
or 16K ND table
16K ARP table
or 8K ND table
16K ARP table or 8K ND table
when
arp mode uni
is not
configured
32K ARP table or 16K ND table
when
arp mode uni
is
configured
ILM table capacity 8K 4K 4K
I
ncoming VLAN mapping table
capacity
16K 8K 8K
O
utgoing VLAN mapping table
capacity
8K 4K 4K
To set the table capacity mode:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Set the table capacity
mode.
switch-mode
{
0
|
1
|
2
}
The default table capacity mode is 0.
This setting takes effect after a
reboot. Before rebooting the switch,
make sure you know the possible
impact of the reboot on the network.
Rebooting the device
CAUTION:
•
A device reboot might interrupt network services.
•
To avoid configuration loss, use the save command to save the running configuration before a
reboot. For more information about the save command, see Fundamentals Command
Reference.
•
Before a reboot, use the display startup and display boot-loader commands to verify that
the
startup configuration file and startup software images are correctly specified. If a startup
configuration file or software image problem exists, the device cannot start up correctly
. For more
information about the two display commands, see Fundamentals Command Reference.
The following device reboot methods are available:
•
Immediately reboot the device at the CLI.
•
Schedule a reboot at the CLI, so the device automatically reboots at the specified time or after
the specified period of time.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English