HPE FlexNetwork 5510 HI Series

33
Figure 13 Login page
IMPORTANT:
Do not
directly close the HyperTerminal. Doing so can cause some modems to stay in use, and you
r
subsequent dial-in attempts will always fail.
To disconnect the PC from the device, execute the appropriate ATH command in the HyperTerminal.
If the command cannot be entered, enter AT+ + +. When the word OK appears, execute the ATH
command. The connection is terminated if OK is displayed. You can also terminate the connection by
clicking in the HyperTerminal window.
Displaying and maintaining CLI login
Execute display commands in any view and the other commands in user view.
Task
Command
Remarks
Display online CLI user
information.
display users
[
all
]
N/A
Display user line
information.
display line
[ num1 | {
aux
|
vty
}
num2 ] [
summary
]
N/A
Display the source
address or interface for
outgoing Telnet packets
when the device acts as a
Telnet client.
display telnet client
N/A
Release a user line.
free line
{ num1 | {
aux
|
vty
} num2 }
Multiple users can log in to the device to
simultaneously configure the device.
When necessary, you can execute this
command to release some connections.
You cannot use
this command to
release the connection you are using.
Lock the current user line.
lock
By default, the system does not lock any
user lines.
This command is not supported in FIPS
mode.