175
a. As shown in Figure 67, click the icon in the Port Group Information Management column
of device NAS to enter the port group configuration page.
b. Click Add to enter the page shown in Figure 68.
c. Enter the port group name.
d. Select the configured IP address group.
The IP address used by the user to access the network must be within this IP address
group.
e. Use the default settings for other parameters.
f. Click OK.
Figure 67 Device list
Figure 68 Adding a port group
5. Select User Access Manager > Service Parameters > Validate System Configuration from
the navigation tree to validate the configurations.
Configuring the switch
1. Configure a RADIUS scheme:
# Create a RADIUS scheme named rs1 and enter its view.
<Switch> system-view
[Switch] radius scheme rs1
# Specify the primary authentication server and primary accounting server, and configure the
keys for communication with the servers.
[Switch-radius-rs1] primary authentication 192.168.0.112
[Switch-radius-rs1] primary accounting 192.168.0.112
[Switch-radius-rs1] key authentication simple radius
[Switch-radius-rs1] key accounting simple radius
# Exclude the ISP domain name from the username sent to the RADIUS server.
To Next Page
Loading...
Need help?
General