HPE FlexNetwork 5510 HI Series

181
Verifying the configuration
# Verify that the portal configuration has taken effect.
[Switch] display portal interface vlan-interface 100
Portal information of Vlan-interface 100
VSRP instance: --
VSRP state: N/A
Authorization Strict checking
ACL Disabled
User profile Disabled
IPv4:
Portal status: Enabled
Authentication type: Direct
Portal Web server: newpt
Authentication domain: Not configured
Pre-auth IP pool: Not configured
BAS-IP: Not configured
User Detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Mask
Destination authenticate subnet:
IP address Mask
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Pre-auth IP pool: Not configured
BAS-IPv6: Not configured
User detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Prefix length
Destination authenticate subnet:
IP address Prefix length
A user can perform portal authentication through a Web page. Before passing the authentication, the
user can access only the authentication page http://2.2.2.1:2331/portal and all Web requests will be
redirected to the authentication page. After passing the authentication, the user can access other
network resources.
# After the user passes authentication, use the following command to display information about the
portal user.
[Switch] display portal user interface vlan-interface 100