Function Key Features and
Settings
152
Zero Touch
You can use this key feature to configure auto provision and network parameters quickly.
This feature is supported on the version 1.0.3.82 or later
To configure the zero touch via Phone interface
1. Press Menu →Features →Function Keys →Line Keys as Function Keys → Line
Key2(for example)
2. Press and key to select the Zero Touch
3. Press or Save soft key to save the configuration
To configure the zero touch via Web interface:
1. Click Function Keys →Line Key.
2. Select the desired Key and select Zero Touch in the Type.
3. Click the button to save the configuration.
To use the zero touch feature on the user interface:
1. Press the Zero Touch key when the IP Phone is idle.
2. Press the OK soft key and the IP Phone will enter the WAN Port interface; you can
change the WAN Type by pressing the Navigation keys.
3. Press the Next soft key to enter Network interface, then you can configure some
information.
4. Press the Next soft key again, you can configure auto provision information.
5. When you finish the setting, you can press the OK to accept the changes.
Note:
This feature is not available on all servers. For more information, contact your
system administrator.
To Next Page
Loading...
