Recording data can be stored only after you install and initialize the disks.
1. Choose Local Conguration > Local Disk.
2. In the upper right corner of the RAID Groups area, click Initial Disk
3. Congure disk initialization.
Figure 5-58 Disk initialization (RAID 5 economical conguration by default)
Step 4 Modify the IP address for the IVS1800.
1. Choose Local
Conguration > Server conguration. Set the service IP
address (internal IP address of the IVS1800), time zone, and time according to
the site requirements.
Figure 5-59
Conguring the server (Single Mode by default)
Set Business IP to XXX.XXX.XXX.XXX, Subnet mask to 255.255.255.0, and Gateway IP
to XXX.XXX.XXX.XXX. The values here are examples. The actual value prevails.
2. Change the PC IP address to an address in the network segment of the new
IVS1800 IP address, enter the IVS1800 IP address in the address box of the
Internet browser, and log in to the OMU portal system.
3. (Optional)
Congure the NTP synchronization. After setting The NTP clock
source server to Yes, set the IP address of the NTP server.
FusionModule800 Smart Small Data Center
User Manual 5 Power-On Commissioning
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. 324
To Next Page
Loading...
Need help?
General