3. Remove the bottom plate of the water detector from the Converged Cabinet.
Figure 6-68 Removing the bottom plate of the water detector
4. Install a new water detector in the Converged Cabinet by referring to the
preceding steps.
5. Connect the new water detector to the conversion cable.
Figure 6-69 Connecting a conversion cable to a water detector
Step 2 Replace a water detection cable.
1. Remove the faulty water detection cable from the port.
2. Install a new water detection cable.
FusionModule800 Smart Small Data Center
User Manual 6 O&M
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. 477
To Next Page
Loading...
