The interface view of an interface at one end of the link is displayed.
Step 3 Run:
efm error-code period period
The period for detecting errored codes on the interface is set.
By default, the period for detecting errored codes on an interface is 1 second.
Step 4 Run:
efm error-code threshold threshold
The threshold for detecting errored codes on the interface is set.
By default, the threshold for detecting errored codes on an interface is 1.
Step 5 Run:
efm error-code notification enable
The interface is enabled to detect errored codes.
By default, an interface cannot detect errored codes.
----End
4.4.4 (Optional) Detecting Errored Frame Seconds of EFM OAM
When an interface is enabled to detect errored frame seconds, the S6700 generates an errored
frame seconds summary event and notifies the peer, if the number of errored frame seconds
reaches or exceeds the threshold within a set period.
Context
An errored frame second is a one-second interval during which at least one errored frame is
detected. It specifies the seconds when errored frames are deteced.
Do as follows on the devices at one end or both ends of the link:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view of an interface at one end of the link is displayed.
Step 3 Run:
efm error-frame-second period period
The period for detecting errored frame seconds on the interface is set.
By default, the period for detecting errored frame seconds on an interface is 60 seconds.
Step 4 Run:
efm error-frame-second threshold threshold
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 4 Ethernet OAM Configuration-EFM
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
158
To Next Page
Loading...
Need help?
General
