Huawei Quidway S6700 series User Manual

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
smart-link group group-id
The Smart Link group view is displayed.
Step 3 Run:
restore enable
Revertive switching is enabled for the Smart Link group.
By default, the revertive switching of the Smart Link group is disabled.
Step 4 (Optional) Run:
timer wtr wtr-time
The wait to recover (WTR) time of the Smart Link group is set.
By default, the WTR time of a Smart Link group is 60 seconds.
----End
2.2.7 (Optional) Enabling the Receiving of Flush Packets
Context
An interface receives Flush packets only when it is configured with the control VLAN ID and
added to this VLAN.
Do as follows on SwitchA, SwitchB, and SwitchC shown in Figure 2-1.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The view of the downlink interface of the SwitchA, SwitchB, or SwitchC is displayed.
Step 3 Run:
smart-link flush receive control-vlan vlan-id [ password simple password ]
The interface is enabled to receive Flush packets, and the control VLAN ID and password
contained in Flush packets are set.
The password is optional. If no password is specified, no password is used for authentication.
When the control VLAN ID is changed, the password must also be changed.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 2 Smart Link and Monitor Link Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
22

Huawei Quidway S6700 series Specifications

General

Brand	Huawei
Model	Quidway S6700 series
Category	Network Router
Language	English