Huawei Quidway S6700 series - Example for Configuring Tangent RRPP Rings with Multiple Instances

#
interface XGigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 5 to 6 10 to 11 100 to 300
stp disable
#
interface XGigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 5 to 6 10 to 11 100 to 300
stp disable
#
return
l Configuration file of PE-AGG
#
sysname PE-AGG
#
vlan batch 5 to 6 10 to 11 100 to 300
#
rrpp enable
rrpp linkup-delay-timer 1
#
stp region-configuration
instance 1 vlan 5 to 6 100 to 200
instance 2 vlan 10 to 11 201 to 300
active region-configuration
#
rrpp domain 1
control-vlan 5
protected-vlan reference-instance 1
ring 1 node-mode master primary-port XGigabitEthernet 0/0/1 secondary-port
XGigabitEthernet 0/0/2 level 0
ring 1 enable
rrpp domain 2
control-vlan 10
protected-vlan reference-instance 2
ring 1 node-mode master primary-port XGigabitEthernet 0/0/2 secondary-port
XGigabitEthernet 0/0/1 level 0
ring 1 enable
#
interface XGigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 5 to 6 10 to 11 100 to 300
stp disable
#
interface XGigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 5 to 6 10 to 11 100 to 300
stp disable
#
return
3.6.6 Example for Configuring Tangent RRPP Rings with Multiple
Instances
Networking Requirements
As shown in Figure 3-10, UPE A, UPE B, UPE C, and UPE D form two multi-instance rings:
ring 1 in domain 1 and ring 1 in domain 2. UPE D, UPE E, UPE F, and UPE G form ring 1 in
domain 3. Packets of the data VLANs connected to CE are forwarded to the backbone network
through the two tangent rings.
The tangent point of the two rings is UPE D.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
130