Bind Peer IP Address : 224.0.0.184
NextHop Ip Address : 224.0.0.184
Bind Interface : XGigabitEthernet0/0/1
FSM Board Id : 0 TOS-EXP : 7
Min Tx Interval (ms) : 1000 Min Rx Interval (ms) : 1000
Actual Tx Interval (ms): 1000 Actual Rx Interval (ms): 1000
Local Detect Multi : 3 Detect Interval (ms) : 3000
Echo Passive : Disable Acl Number : -
Destination Port : 3784 TTL : 255
Proc Interface Status : Disable
WTR Interval (ms) : -
Active Multi : 3
Last Local Diagnostic : No Diagnostic
Bind Application : No Application Bind
Session TX TmrID : - Session Detect TmrID : -
Session Init TmrID : - Session WTR TmrID : -
Session Echo Tx TmrID : -
PDT Index : FSM-0 | RCV-0 | IF-0 | TOKEN-0
Session Description : -
--------------------------------------------------------------------------------
Total UP/DOWN Session Number : 1/0
----End
Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
#
bfd
#
bfd atob bind peer-ip default-ip interface XGigabitEthernet0/0/1
discriminator local 1
discriminator remote 2
commit
#
return
l Configuration file of Switch B
#
sysname SwitchB
#
bfd
#
bfd btoa bind peer-ip default-ip interface XGigabitEthernet0/0/1
discriminator local 2
discriminator remote 1
commit
#
return
5.9.2 Example for Configuring Single-Hop BFD on a VLANIF
Interface
Networking Requirements
The S6700s are connected through the VLANIF interface at Layer 3. To detect the connectivity
of the link between two directly connected S6700s, you can configure single-hop BFD to bind
the BFD session to the VLANIF interface and its IP address.
As shown in Figure 5-2, a BFD session is created to detect the connectivity of the link between
Switch A and Switch B.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 5 BFD Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
205
To Next Page
Loading...
Need help?
General
