Huawei Quidway S6700 series - Enabling BFD Globally

No. Data
2 Peer IP address, local interface type and number for the directly-connected link
detected by BFD, and default multicast address used by BFD if it checks the physical
layer status of the link
3 BFD session parameters: local and remote discriminators
5.3.2 Enabling BFD Globally
Context
Do as follows on S6700s at both ends of the link to be detected.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd
BFD is enabled globally and the BFD view is displayed.
By default, BFD is disabled globally. Before configuring the BFD functions, you must enable
BFD globally; otherwise, the configuration fails.
----End
5.3.3 (Optional) Setting the Multicast IP Address of BFD
Context
Do as follows on S6700s at both ends of the link to be detected.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd
The BFD view is displayed.
Step 3 Run:
default-ip-address ip-address
The multicast IP address of BFD is set.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 5 BFD Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
186